---------------------------------------------------------------------

next up previous contents
Next: Create huge PAD figure Up: About parameter variables Previous: Add a frame to

---------------------------------------------------------------------

Enlarge or shrink all

In pad2ps series you can enlarge or shrink PAD figures freely, both in vertical and in horizontal. The magnification ratio is set using hrate  for horizontal and vrate  for vertical. The value may be a fraction number. The default value is 1.0 for both cases.

Too large hrate value will result in too large output that would not fit in the page even with folding, and in this case hrate will be adjusted automatically. You can use this feature to create the largest output; it is done by setting the value fairly large and let your computer readjust the value. Of course, you can enlarge as much as you want when the parameter poster is set on, thereby disabling the folding feature.

On contrary, vrate may be set as large as you like.

---------------------------------------------------------------------

Go back to pad2ps - automatic PAD drawer.
Go back to Seiichi Yoshida's Home Page.
Copyright(C) Seiichi Yoshida (comet@aerith.net). All rights reserved.
Sun Nov 10 01:36:04 JST 1996